To configure the interlock, you’ll be asked a series of questions. The questions will
vary depending on the equipment that will be configured and cannot all be cov-
ered in this manual. In general, you’ll select equipment that will be monitored and
equipment that will be affected. The equipment could be pumps, valves, heaters,
lights, etc. The affected equipment will activate/deactivate depending on the state of
the monitored equipment. Advance through the configuration and when finished, a
summary screen will be displayed. The summary will describe how the interlocked
equipment will function. Read through the description and make sure the equipment
will function as desired.
If Equipment to Sensor is selected:
This interlock is similar to above, but the monitored equipment will be a sensor. The
monitored sensor can be any sensor, flow switch or external input that has been
configured for use with the OmniPL. The affected equipment will activate/deactivate
depending on the state of the monitored sensor. For flow switch sensors, affected
equipment will turn on/off when the flow switch detects flow or no flow. For tem-
perature sensors, affected equipment will activate/deactivate when the temperature
is higher or lower than a desired setpoint. For external inputs, affected equipment
will turn on/off when the switch is actuated. Advance through the configuration and
when finished, a summary screen will be displayed. The summary will describe how
the interlocked equipment will function. Read through the description and make sure
the equipment will function as desired.
If Equipment to Mode is selected:
With Equipment to Mode interlock, affected equipment will activate/deactivate based
on which mode the OmniPL is in; Pool, Spa or Spillover. You can configure this inter-
lock to turn on/off equipment whenever the OmniPL goes into one of these available
modes. Advance through the configuration and when finished, a summary screen
will be displayed. The summary will describe how the interlocked equipment will
function. Read through the description and make sure the equipment will function
as desired.
If Theme to Sensor is selected (at least one Theme must be configured, see Operation
Manual):
This interlock is similar to the Equipment to Sensor interlock but a Theme is affected
instead. As explained in the Operation manual, Themes are created to execute many
pool functions with a single button. With a Theme to Sensor interlock, the Theme
will run or stop depending on the state of the monitored sensor. For flow switch
sensors, the Theme will run or stop when the flow switch detects flow or no flow.
For temperature sensors, the Theme will run or stop when the temperature is higher
or lower than a desired setpoint. For external inputs, the Theme will run or stop
when the switch is actuated. Advance through the configuration and when finished,
a summary screen will be displayed. The summary will describe how the interlocked
Theme will function. Read through the description and make sure the equipment will
function as desired.
If Spillover to External Input is selected (requires that you have an external input config-
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
48
