full configuration for adding a new accessory to the Backyard. These steps are described
in the Configuration Wizard portion of this manual.
Select an Accessory -
Once you select an accessory, all of the options for that Backyard
accessory will appear on the next screen. These options are as follows:
Name -
Rename the accessory to whatever name is desired.
Relay -
Select the relay that the accessory is wired to.
Delete an Accessory -
From this screen, if you wish to delete an accessory that is cur-
rently configured, select the trash can on the right of the name of the accessory that you
wish to delete.
NOTE: The system does not allow you to configure a pump or a valve to accessory equipment
in the Backyard.
If Sensors is selected:
Add Sensor -
Pressing “Add Sensor” from this screen will take you through the full configuration for
adding a new sensor. These steps are described in the Configuration Wizard portion of this manual.
Select a Sensor -
Once you select a sensor, all of the options for that sensor will appear on the next
screen. These options are as follows:
Name -
Rename the sensor to whatever name is desired.
Location -
Select the location that the sensor is wired to.
Delete a sensor -
From this screen, if you wish to delete a sensor that is currently configured,
select the trash can on the right of the name of the sensor that you wish to delete.
If Interlocks is selected:
Add Interlock -
Pressing “Add Interlock” from this screen will take you through the full configura-
tion for adding a new interlock. These steps are described in the Configuration Wizard portion of
this manual.
Select an Interlock -
Selecting an interlock from this screen will allow you to view that interlock’s
configuration. However, you cannot edit a pre-existing interlock. In order to change an interlock’s
configuration, you have to delete the obsolete interlock and create a new one.
Delete an Interlock -
From this screen, if you wish to delete an interlock that is currently config-
ured, select the trash can on the right of the name of the interlock that you wish to delete.
NOTE: If there are currently no interlocks configured on your system, then the button will appear as
“Add Interlock” instead of “Interlocks”. In this case, pressing “Add Interlock” will take you through
the full configuration for adding a new interlock. These steps are described in the Configuration
57
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
