Installation Steps
DANGER of Death, Injury or Property Damage if procedure not followed.
Dead front removal
is required for this installation. Power to the OmniPL panel MUST be shut off before the dead front
is removed. This means a complete shutdown of power to the entire OmniPL panel.
Details on each installation step are presented on the following pages:
1. Mounting the equipment (page 6)
2. Plumbing (page 10)
3. Electrical Wiring (page 14)
4. Prepare the pool water (page 25)
5. System Startup and Firmware Upgrade (page 28)
NOTE: If replacing a Pro Logic Controller using networked ColorLogic Lights, the lights must be put
into “Standalone” (default) mode before disconnecting the Pro Logic. The OmniPL can only control
ColorLogic lights in “Standalone” mode.
Service Power
from
Main Panel
OmniPL Wiring Panel
(Optional)
Smart Relay
Variable
Speed Pump
Filter
Valve
Actuator
Heater
TO
POOL
FROM
POOL
Power to VSP
directly from
electrical panel
Power to
Valve Actuator
Comm.
to VSP
To Solar
Power to Smart Relay
directly from
electrical panel
Comm. to Smart Relay (15’)
OmniPL Controller
To Feature,
Accessory,
Lights, etc.
Wireless
Connection
OR
Ethernet to
Router
Comm. to Control (15’)
Sensor 1
(Water Temp.)
Sensor 2
(Air Temp.)
Sensor 3 (Solar OR
External Input)
(Optional)
Flow Switch
REMOTE
RELAY
OFFLINE:
ON/OFF
Power to Heat Pump
directly from
electrical panel
Flow
Switch
Turbo
Cell
5
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
