H3C XE 200 IP, Operation Manual

Page: 98 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-14
The default value of the route priority is 10. The larger the value is, the higher the
priority will be.
XI. Configuring the static route number of a gateway
When a user calls a number and you have set a static route number for a gateway or an
office device configured on an LS, the request will be forwarded to the gateway or office
device for query. When multiple numbers that comply with a certain rule are to be
routed to the same device, you can configure a regular expression to match these static
numbers to decrease the length of the LS’s routing table, improve the LS’ executing
efficiency, and shorten the LS’ responding time.
Note:
When using the regular expression to match the dialed number, the system
automatically begins the match from the beginning of the regular expression. If the first
judgment is true, the match goes on; otherwise, the match fails. You do not need to add
a caret (^) at the beginning of the expression, because the system has added it by
default. For details about the regular expression, refer to the Basic Configuration part of
the H3C XE 200/2000 IP PBX Operation Manual .
Perform the following configuration in LS-GW view.
Table 1-19 Configure the static route number of a gateway
Operation Command
Configure the static route number of a
gateway
prefix number
Delete one or all static route numbers undo prefix { number | all }
Note:
When configuring the static route number, make sure that it does not conflict with the
ONLY number, the automatic operator number and the group notification number. For
detailed information, refer to the “Call Services Operation” module of this manual.
XII. Specifying whether a gateway needs to perform authentication
The LS can determine whether to authenticate register and call requests sent from the
UA. If authentication is disabled, the UA can register with the registrar and place voice
calls without authentication; if authentication is enabled, the UA must pass the
authentication first.