H3C XE 200 IP, Operation Manual

Page: 109 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-25
Table 1-39 Configure a subscriber line number of a gateway and enter the
corresponding subscriber view
Operation Command
Create a number entry for a subscriber
line of a gateway and enter the
corresponding subscriber view
subscriber short-number long-number
Delete one or all of the entries of a
gateway undo subscriber { short-number
long-number | all }
Note:
z
The XE IP PBX supports multiple called parties, which allows number entries
configured (on one or multiple gateways) with the same long number but respective
short numbers.
z
When configuring the subscriber line number, make sure that it does not conflict
with the ONLY number, the automatic operator number and the group notification
number. For detailed information, refer to the “Call Services Operation” module of
this manual.
IV. Configuring the priority of a subscriber line number of a gateway.
Perform the following configuration in subscriber view.
Table 1-40 Configure the priority of a subscriber line number of a gateway
Operation Command
Configure the priority of a subscriber line
number of a gateway
priority priority-level
Configure the default priority undo priority
By default, the subscriber line number uses the priority of a gateway. Refer to
Configuring the default route number priority of a gateway .
V. Configuring the time-to-live value of registration
The time-to-live value refers to the length of time interval within which the registration
information of a gateway is valid. A PS accepts a call from a gateway during a specified
time-to-live interval.