H3C XE 200 IP, Operation Manual

Page: 317 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX
Chapter 6 User Management
6-5
II. Authorizing the User to use a Type of Service
Use the local-user command to authorize the local user to use a type of service.
Perform the following configuration in system view.
Table 6-6 Authorize the user to use a type of service
Operation Command
Authorize the user to use a type of
service local-user local-user service-type { ftp
| terminal | telnet }*
Restore the default service type of the
user undo local-user local-user
service-type
By default, the user is authorized to use all types of services.
III. Setting the user level
The user level is prior to the privilege level of user interface. This means that when both
levels are set, and the user logs in via the user interface terminal, the level is
determined by the user level.
Perform the following configuration in system view.
Table 6-7 Set the user level
Operation Command
Set the user level local-user username level level
Restore the default user level undo local-user local-user level
The user level is determined by the parameter level , which ranging from 0 to 3. Level 0
is the lowest level and level 3 is the highest. The user level is not set by default.
6.3 AAA Configuration
6.3.1 Introduction to AAA
I. Functions
Authentication, Authorization, and Accounting (AAA) provides users with security
functions of AAA described as follows:
z
Authentication: To authenticate users to access the network.
z
Authorization: To authorize a user to use specific services.
z
Accounting: To record the utility of the network resources.