H3C XE 200 IP, Operation Manual

Page: 326 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX
Chapter 7 SNMP Configuration
7-6
[XE] snmp-agent usm-user v3 John Johngroup authentication-mode md5 hello
7.2.6 Setting System Contact
S ystem contact of the administrator is a management variable of the system group in
MIB II and it contains the ID and contact of relevant administrator of the managed
devices (XE IP PBX). Store the important information in the XE IP PBX through
configuring this parameter and you can query when emergency occurs.
Perform the following configuration in system view.
Table 7-7 Set/restore system contact
Operation Command
Set the ID and contact of the
administrator snmp-agent sys-info contact
sysContact
Restore the default ID and contact of the
administrator
undo snmp-agent sys-info contact
Example:
[XE] snmp-agent sys-info contact Mr.zhang 13800138002
7.2.7 Enable/Disable Trap Packets
Traps packets are messages sent to the NMS without solicitation by the managed
device on its own initiatives, reporting some emergent and significant events.
Perform the following configuration in system view.
Table 7-8 Allow/forbid Trap packets
Operation Command
Enable the trap packets snmp-agent trap enable [ trap-type [ trap-list ] ]
Disable the trap packets undo snmp-agent trap enable [ trap-type [ trap-list ] ]
By default, trap packets are disabled.
The command snmp-agent trap enable without any parameter indicates to enable all
types of trap packets in all modules.
7.2.8 Setting the Engine ID of a Local Device
Use the configuration to set the engine ID of a local device. The engine ID is a
hexadecimal string consisting of 10 to 64 characters and is the number of the
characters must be an even number. By default, the engine ID of the device is