H3C XE 200 IP, Operation Manual

Page: 90 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-6
party, and the call is placed under the control of the PS and the LS. In redirect mode,
the PS directly responds with the IP address of the called party to the calling party (if the
IP address of the called party is stored in the LS), and then the calling party calls the
called party.
Note:
For networks containing both H.323 and SIP devices, you need to set call mode of both
SIP Server and gatekeeper as “routed” to achieve interworking between SIP and H.323
terminals.
Perform the following configuration in LS view.
Table 1-3 Configure call mode
Operation Command
Configure call mode call-mode { h323 | sip } { redirect | routed }
Restore the default call mode undo call-mode { h323 | sip }
1.3.4 Enabling/Disabling an LS
An LS is disabled by default. You need to enable an LS to implement the functions it
provides.
Perform the following configuration in LS view.
Table 1-4 Enable/disable an LS
Operation Command
Enable an LS
start
Disable an LS stop
1.3.5 Configuring Call-matching Criterion
This command is used to configure call-matching criterion for called numbers.
Perform the following configuration in LS view.