H3C XE 200 IP, Operation Manual

Page: 405 / 514

Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 10 Call Forwarding Services
10-2
10.2 CFU Service
10.2.1 Introduction to CFU Service
With the CFU service, all incoming calls are forwarded to the target number preset by
the callee, and the telephone set of the callee does not ring. Up to two forwarded-to
numbers can be set by the callee.
10.2.2 Using CFU Service
After the administrator enables the CFU service for a subscriber, target forwarding
numbers can be set by the following two methods.
z
The administrator can set the number on the XE IP PBX through command lines.
Refer to 10.2.3 “ Configuration Procedure ” for details.
z
The subscriber can set the number on the telephone set as follows:
I. Setting CFU target number on the telephone set
The following table describes how to set the CFU target number on the telephone set.
Table 10-1 Set CFU target number on the telephone set
Step Expected result
Pick up the phone. The subscriber can hear the dial tone.
Dial *57*, the target
forwarding number and # in
sequence.
If the setting succeeds, the subscriber can hear the
ringback tone or the voice prompt “You have
successfully activated the service.”
If the setting fails, the subscriber will hear the busy
tone or the voice prompt “Sorry, your attempt to
activate the service was unsuccessful.”
Hang up the phone. —
II. Checking the existence of a target number on the telephone set
The following table describes how to verify the CFU target number, that is, to check
whether a specified number is set as the CFU target number on the telephone set.