H3C XE 200 IP, Operation Manual

Page: 286 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX
Chapter 4 System Maintenance and Management
4-4
1
2
3
Protocol debugging switch
ON ON OFF
ON OFF
1
3
1
3
Screen output switch
1
3
Debugging information
Figure 4-1 Send debugging information
Use the debugging command to enable/disable protocol debugging.
Perform the following configuration in user view.
Table 4-3 Enable/disable/display debugging
Operation Command
Enable protocol debugging
debugging { all | module-name
[ debug-option1 ] [ debug-option2 ] …}
Disable protocol debugging
undo debugging { all | module-name
[ debug-option1 ] [ debug-option2 ] … }
Display the enabled debugging
display debugging [ interface
{ interface-type interface-number |
interface-name } ] [ module-name ]
Refer to related sections for usage and debugging information formats of the above
debugging commands.
The information center controls the screen output debugging. See the section 4.2
“ Information Center “ for more information.
4.1.3 Rebooting the System
You need to reboot your XE IP PBX when the system file is updated. You can power off
the XE IP PBX and reboot it or use the reboot command.
Perform the following configuration in user view.