H3C XE 200 IP, Operation Manual

Page: 91 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-7
Table 1-5 Configure call-matching criterion
Operation Command
Configure the longest number at higher
priority
policy select-rule number-first
Configure the priority number at higher
priority
policy select-rule priority-first
1.3.6 Configuring Whether to Accept Requests from an Unknown Device
The command is used to configure whether to accept requests from an unknown
device.
Perform the following configuration in LS view.
Table 1-6 Configure whether to accept requests from an unknown device
Operation Command
Configure to enable accepting requests
from an unknown device policy unknown-device-admission
enable
Configure to disable accepting requests
from an unknown device policy unknown-device-admission
disable
1.3.7 Configuring a PS Registered with an LS
When acting as an LS, an XE IP PBX can manage multiple PSs. You must configure an
IP address and a heartbeat password for each managed PS on the LS.
To configure managed PSs, you must enter LS-PS view first, where IP addresses and
heartbeat passwords are configured.
I. Adding a PS or entering a PS view
If a specific LS-PS view already exists, you can enter it directly; if not, you must create
a new PS first, and then enter the corresponding LS-PS view.
Perform the following configuration in LS view.
Table 1-7 Add/delete a PS or enter a PS view
Operation Command
Add a PS or enter a PS view process-server device-id
Delete a specified PS or all PSs undo process-server { device-id | all }