H3C XE 200 IP, Operation Manual

Page: 316 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX
Chapter 6 User Management
6-4
Table 6-4 Set the privilege level of user interface
Operation Command
Set the privilege level of user interface user privilege level level
Restore the default privilege level of
user interface
undo user privilege level
By default, the privilege level of user interface for CON port is 3, and the privilege level
of other user interfaces is 0.
6.2.3 Configuring Local-Authenticated Users
I. Configuring the user name
Use the local-user command to configure a local user for local authentication. You
must configure a user name first, then the user type and the privilege level. When
configuring a user, a password is not mandatory, in which case you can log in by simply
pressing <Enter>.
Perform the following configuration in system view.
Table 6-5 Set the user name and the password for local authentication
Operation Command
Set a user name and a password
local-user local-user [ password
{ cipher | simple } password ]
Delete a user
undo local-user local-user
simple : Represents a plain text password, that is, the password is displayed in plain
text when using the display command to view the information about the user.
cipher : Represents an encrypted text password, that is, the password is displayed in
encrypted text when using the display command to view the information about the
user.
Note:
When you press <Enter> immediately after typing the local-user local-user command,
if there is no such existing user, the system will create a new user, otherwise, it will not
create a new user, nor makes changes to the original one with the same name.