H3C XE 200 IP, Operation Manual

Page: 193 / 514

Operation Manual – Feature
H3C XE 200/2000 IP PBX
Chapter 1 Number Substitution
1-9
1.4.8 Configuring Rule-Based Number Substitution
I. Enabling/disabling rule-based number substitution
When rule-based number substitution is enabled, the system substitutes numbers
based on the applied policy and rules. Disabling the function will invalidate substitute
rules.
Perform the following configuration in LS view.
Table 1-8 Enable/disable rule-based number substitution
Operation Command
Enable rule-based number substitution
policy num-substitute enable
Disable rule-based number substitution policy num-substitute disable
By default, rule-based number substitution is enabled.
II. Configuring/deleting substitute rules for static route numbers
For each static route number, you can configure up to two substitute rules.
Perform the following configuration in prefix view.
Table 1-9 Configure/delete a substitute rule for the static route number
Operation Command
Configure a substitute rule for the static
route number
prefix-rule rule-tag { caller input-format
output-format [ callee input-format
output-format ] | callee input-format
output-format } { before | after }
Delete the specified or all substitute
rules for the static route number
undo prefix-rule { rule-tag | all }
By default, no substitute rule is configured for the static route number.
III. Configuring/deleting substitute rules for devices
For a gateway or office group, you can create number substitute rules as the number
substitution policy for all calls related to the gateway or office group.
Note:
You can create up to eight number substitution rules for each gateway or office group.
Perform the following configuration in LS-GW view or LS-OFFICEGROUP view.