H3C XE 200 IP, Operation Manual

Page: 11 / 514

Operation Manual – Basic Configuration
H3C XE 200/2000 IP PBX
Chapter 2 Command Line Interface for Configuration
2-1
Chapter 2 Command Line Interface for
Configuration
2.1 Setting Up the Configuration Environment
The XE IP PBX provides the configuration command line interface, with which you can
configure the XE IP PBX locally or remotely through:
z
CONSOLE port
z
AUX port
z
Telnet
2.1.1 Configuring the XE IP PBX through the CONSOLE Port
Step 1: Connect the serial port on a PC (or terminal) to the CONSOLE port on the XE IP
PBX using a console cable, as shown in Figure 2-1 .
Figure 2-1 Set up a local configuration environment through the CONSOLE port
Step 2: Run the terminal emulation program (HyperTerminal of Win9X for example) on
the PC and set the terminal communications parameters as follows:
Bits per second: 9600 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Terminal emulation type: VT100
See Figure 2-2 through Figure 2-4 .