GSi EVO-50, Construction Manual, Page: 115 / 222

Chapter 7: Door Assemblies
Installing the Latch Bar Holders
The door latch bar (39) holders are used to secure the inner doors tightly against the door frame
weldment.
1. Install eight 1/2" x 1-1/4" HHTB bolts (6) and 1/2" flange nuts (29) to fill in the holes inside of the
outer door frame weldment (31).
NOTE: Install the HHTB bolts (6) with bolt head on the inside of the door frame weldment (31).
2. Install eight latch bar holders (39) to the inside of the inner door frame weldment (33) using
1/2" x 1-1/2" HHTB bolts (7) and 1/2" flat washers (19).
NOTE: Install the HHTB bolt (7) from the outside and 1/2" flat washers (19) from the inside of the
inner door frame weldment (33). Use 1/2" flat washers (19) to adjust the depth of the latch
bar holders (39) in the door frame weldment (33). Do not fully tighten the latch bar holders
(39) until the inside doors are installed and adjusted.
Figure 7-40 Installing the latch bar holders
6
1/2" x 1-1/4" HHTB bolt (S-9062)
31
Outer door frame weldment (NCWT0769) (2-post)
7
1/2" x 1-1/2" HHTB bolt (S-3728) Outer door frame weldment (NCWT0784) (3-post)
19
1/2" flat washer (S-2120)
33
Inner door frame weldment (NCWT0763-BS) (2-post)
Inner door frame weldment (NCWT0779-BS) (3-post)
29
1/2" flange nut (S-10253)
39
Door latch bar holder (WD-6234)
PNEG-5490D-2X 90' Diameter EVO-50 Beam 2X Bin 115