GRASS VALLEY K2 SAN, Installation And Service Manual

Page: 66 / 346

4. Type the following, then press
Enter
:
show qos vlan
The screen displays VLAN information. Note the ID number of the Media (iSCSI) VLAN. It
should be 60, as follows:
VLAN priorities
VLAN ID Apply rule | DSCP Priority
------- ----------- + ------ -----------
1 No-override | No-override
60 No-override | No-override
5. a) Assign the Media VLAN the QOS priority of 3. For example, if the VLAN ID is 60, you type
the following, then press
Enter
.
vlan 60 qos priority 3
b) Type the following, then press
Enter
:
show qos vlan
The screen displays VLAN information. Make sure that the Priority column reports that the
Media VLAN has a value of 3.
Next, verify flow control settings.
Upgrading firmware on HP switch
1. If you have not already done so, install a TFTP Server.
For example, to install
tftpd32.exe
, go to
http://tftpd32.jounin.net/
.
2. Open the TFTP Server.
3. Make sure your current working directory includes the
*.swi
file that you are using for the
upgrade.
4. Execute the copy command with the following syntax:
copy tftp flash <ip-address> <remote-os-file> [ < primary | secondary
> ]
Note that if you do not specify the flash destination, the TFTP download defaults to the primary
flash.
For example, to download a software file named T_13_23.swi from a TFTP server with the IP
address of 10.16.34.3 1, use the following:
ProCurve # copy tftp flash 10.16.34.3 T_13_23.swi
5. When prompted
The primary OS image will be deleted. continue [y/n]?
, press
Y
.
When the switch finishes downloading the software file from the server, it displays the progress
message
Validating and Writing System Software to FLASH...
6. Wait until the CLI prompt re-appears, then continue with the next step in this procedure.
66 K2 SAN Installation and Service Manual 2014 01 27
Setting up the K2 SAN infrastructure