GRASS VALLEY K2 SAN, Installation And Service Manual

Page: 53 / 346

K2-XDP redundant
These cabling instructions apply to the following:
• K2 Summit 3G system or first generation K2 Summit system on a redundant online or production
K2 SAN
Refer to "K2 Summit Production Client Quick Start Guide" for additional cabling details.
!
OK
~AC
C1 C2 C3 C4
USB/1394 100BT/1000BT
GPI
VGA
REF. LOOP THROUGH
!
OK
~AC
To control port
on GigE switch A To control port
on GigE switch B
To media (iSCSI) port
on GigE switch A To media (iSCSI) port
on GigE switch B
Cable Ethernet switch
As directed by the system diagram for your storage system, cable the switch or switches for your
system using the instructions in this section.
These instructions are for the HP ProCurve switch 2900 and 2910 series.
If a different brand of switch, such as a Cisco Catalyst switch, is required by your site, apply the
information in the following procedures accordingly. Refer to the documentation you received with
the switch as necessary.
Install the switch in its permanent location. When installing in a video equipment rack, use 10-32
screws. Do not use HP’s 12-24 screws, as they can cause thread damage.
Provide power to the switch.
K2-SWE basic online/production
These cabling instructions apply to the following:
• HP 29xx series Gigabit Ethernet switch on a basic (non-redundant) online or production K2
SAN.
Front view
2014 01 27 K2 SAN Installation and Service Manual 53
Cabling K2 SAN devices