GRASS VALLEY K2 SAN, Installation And Service Manual

Page: 241 / 346

Powering on K2 G10v2 RAID
This topic applies to K2 G10v2 (M100) RAID.
1. Verify power and cabling.
2. Tap the power button on the controller, as shown.
NOTE: Do not press and hold down the power button.
If the RAID chassis has two controllers, you can tap the power button on either controller. You
do not need to tap both power buttons.
Tapping the power button on a controller also powers on any connected Expansion chassis. There
are no power buttons on Expansion chassis.
3. Wait while the primary RAID chassis performs self-test and initialization. This takes 6-8 minutes.
While this is taking place, the Ready LED is illuminated with a steady on light.
4. Watch for the Ready LED to begin blinking at one second intervals. The LED might turn off
and back on two times before starting the one second blink pattern. When the Ready LED is
blinking at one second intervals, the self-test and initialization is complete and the chassis is
ready for use.
Powering on the HP ProCurve switch
Use the following procedure to power on and verify proper operation of the HP ProCurve switch.
1. Power up the switch.
2. Watch LEDs to verify proper operation.
The diagnostic self test LED Behavior is as follows:
• Initially, all the status, LED Mode and port LEDs are on for most of the duration of the test.
• Most of the LEDs go off and then may come on again during phases of the self test. For the
duration of the self test, the Test LED stays on.
If the ports are connected to active network devices, the LEDs behave according to the LED
Mode selected. In the default view mode (Link), the LEDs should be on.
If the ports are not connected to active network devices, the LEDs will stay off.
Powering on the control point PC
Use the following procedure to power on K2 SAN’s control point PC and verify proper operation
during power up of the system.
1. Power up and log on to the PC using standard Windows procedures.
2014 01 27 K2 SAN Installation and Service Manual 241
Operating the K2 SAN