GRASS VALLEY K2 SAN, Installation And Service Manual

Page: 322 / 346

Network and SNMP settings are set and stored on the RAID controller. Therefore, if the RAID
chassis has two controllers, each controller must be configured separately, as in the following
procedure.
1. In the K2Config application tree view, open the node for a K2 Media Server and select the
File
System Server
node to open its property page. On the property page click
Launch Storage Utility
.
Storage Utility opens. You can now configure the network settings on the controller connected
to the selected K2 Media Server.
2. In the Storage Utility, right-click the icon for a RAID controller and select
Configuration | Network
Properties
. The Network Settings dialog box opens.
3. In the Controller Slot Number field enter
0
and then press
Enter
. The settings from controller 0
are loaded into the Controller Network Settings dialog box and are available for you to modify.
4. Enter the control network IP address and other network settings.
5. You want SNMP trap messages go to a SNMP manager, so for SNMP Configuration enter the
IP address of the SNMP manager PC. You can also enter IP addresses for other SNMP managers
to which you want to send SNMP trap messages.
Refer to related topics about Grass Valley recommended deployment and monitoring solutions
in "K2 Release Notes".
6. If the RAID chassis has two controllers, in the Controller Slot Number field enter
1
and then
press
Enter
. The settings from controller 1 are loaded into the Controller Network Settings dialog
box and are available for you to modify. Repeat the previous steps to configure controller 1.
7. Click
OK
to save settings and close.
322 K2 SAN Installation and Service Manual 2014 01 27
Administering and maintaining the K2 SAN