Order No. 2104 ..
Adjustment via long
actuation?
Yes
No
With a long press (< 5 s), the current
value can be cyclically reduced or
increased by the parameterized step
width (see below) and transmitted. After
this value adjustment, the value last
transmitted remains stored.
This parameter defines whether a value
adjustment is possible
Only with "Transmit value on = rising
edge (push-button as NO contact)" and
"Transmit value on = falling edge (push-
button as NC contact)".
Time between two
telegrams,
Base
130 ms
260 ms
520 ms
1 sec
Time base for the time between two
cyclical telegrams during value
adjustment.
Only with "Adjustment via long
actuation? = Yes"!
Time = Basic x Factor
Time between two
telegrams,
Factor (3...127)
3
...127
Time factor for the time between two
cyclical telegrams during value
adjustment.
Only with "Adjustment via long
actuation? = Yes"!
Time = Basic x Factor
Presetting: 520 ms × 3 = 1.56 s
Step width
1 K
The step width of the adjustment is
permanently set to 1 K. Only with
"Adjustment via long actuation? = Yes".
Behaviour after bus
voltage
return
no reaction
Reaction as rising edge
Reaction as falling edge
Transmit current input
status
It is possible to specify which reaction
should take place after bus voltage
return. If a delay after bus voltage return
is configured, this time must first have
elapsed before the pre-set reaction is
executed here.
With "no reaction", no reaction occurs.
With "Reaction as with rising edge", the
value parameterized for the rising edge
will be transmitted.
Only with "Transmit value on = rising
edge (push-button as NO contact)" and
"Transmit value on = rising and falling
edge (switch)"!
With "Reaction as with falling edge", the
Page 154 of 171
Software "KNX CO2 sensor"
Parameters
