Order No. 2104 ..
Presetting: 520 ms × 10 = 5.2 s
Behaviour after bus
voltage
return
no reaction
Reaction as rising edge
Reaction as falling edge
It is possible to specify which reaction
should take place after bus voltage
return. If a delay after bus voltage return
is configured, this time must first have
elapsed before the pre-set reaction is
executed here.
With "no reaction", no reaction occurs.
With "Reaction as with rising edge", the
light scene parameterized for the rising
edge will be transmitted. Only with
"Transmit light scene number on =
raising edge (push-button as NO
contact)"!
With "Reaction as with falling edge", the
light scene parameterized for the falling
edge will be transmitted. Only with
"Transmit light scene number on =
falling edge (push-button as NC
contact)"!
Value transmitter =
"Temperature value
transmitter"
Transmit value on
rising edge (push-button
as NO contact)
falling edge (push-button as
NC contact)
rising and falling edge
(switch)
Specifies the edge which starts an
actuation.
Value on rising edge
0...
20
...40 °C in 1 °C
increments
Setting of the temperature value to be
transmitted.
Only with "Transmit value on = rising
edge (push-button as NO contact)" and
"Transmit value on = rising and falling
edge (switch)"!
Value on falling edge
0...
18
...40 °C in 1 °C
increments
Setting of the temperature value to be
transmitted.
Only with "Transmit value on = falling
edge (push-button as NC contact)" and
"Transmit value on = rising and falling
edge (switch)"!
Page 153 of 171
Software "KNX CO2 sensor"
Parameters
