AP0902
5–15
Maintenance
5.6
V-belt
WARNING!
To avoid injury, only check or re-tension/replace the V-belt when the engine is
switched off.
☞
Switch off the engine before carrying out maintenance work in the engine
compartment!
Check the V-belt every day or every 10 hours of operation and re-tension it if necessary.
New V-belts should be re-tensioned after about 15 minutes of operating time.
5.6.1
Checking the V-belt tension
☞
Check as follows:
•
Switch off the engine
•
Prevent the machine from rolling away and remove the ignition key
•
Open the engine cover
•
Carefully inspect the V-belt for damage
If the V-belt is damaged:
☞
Replace V-belt
•
Press with your thumb in the middle of the longest section between two pulleys (figure
148) to check whether the V-belt can be deflected, by no more than about 0.4 in (10
mm)
•
Re-tension the V-belt if necessary – see Section 5.6.2 „Re-tensioning the V-belt”
5.6.2
Re-tensioning the V-belt
☞
Re-tension as follows:
•
Switch off the engine
•
Prevent the machine from rolling away and remove the ignition key
•
Open the engine cover
•
Unscrew swivel screws 148/3 on the alternator and the set screw on
adjustment bracket 148/2
•
Use a suitable tool to move the alternator until the correct V-belt tension is obtained
•
Keep the alternator in this position
•
Firmly tighten swivel screw 148/3 on the alternator and the set screw on
adjustment bracket 148/2
•
Check the V-belt tension once again. Check the V-belt tension again after the first 25
service hours if a new V-belt is mounted
Fig. 148: Checking the V-belt tension
Summary of Contents for 418T Wheel
