![background image](http://html1.mh-extra.com/html/gehl/418t-wheel/418t-wheel_operators-manual_2205856131.webp)
5–18
AP0902
Maintenance
Under the rear end of the machine:
•
Place a suitable container to collect the oil as it drains, with a minimum capacity
of 15 gallons (55 liters)
•
Remove filler cap C of the oil drain valve
•
Screw oil drain coupling D onto the oil drain valve, with a sufficiently long hose,
making sure the end of the hose is in the container
➥
Oil drain valve E opens and the oil drains into the container
•
Flush out the hydraulic oil tank with a small amount of hydraulic oil
•
Remove oil drain coupling D on oil drain valve E
•
Screw on filler cap C of the oil drain valve
•
Replace the hydraulic oil return filter– see Hydraulic oil return filter on page 5-20
•
Check the whether the filling screen is intact
Important!
If the hydraulic oil is contaminated, there is a risk of severe damage in the
hydraulic system.
☞
Always add hydraulic oil using the filling screen!
•
Fill the system with fresh hydraulic oil up to the middle 149/A of the oil level sight
glass
•
Screw on cover 150/B of the hydraulic oil tank
•
Start the engine
At a low engine speed:
•
Fully extend the lift and tilt cylinders on the telescopic unit
•
Turn the steering wheel to the left and right several times, from lock to lock
•
Retract all the hydraulic cylinders again
•
Switch off the engine
•
Check the hydraulic oil level again and top up again if necessary
Fig. 151: Oil drain valve with cap
C
D
E
Summary of Contents for 418T Wheel
