Gehl 418T Wheel, Operator'S Manual

Page: 50 / 192

AP0902
3–13
Operation
3.4.2 Warning Lights: overview
Unfold page 3-4 for a better overview!
35 Warning Light (red) – alternator charge function
The warning light comes on when the ignition is turned on and goes out as soon as the
engine is running.
The V-belt for the alternator, or the charging circuit of the alternator is faulty if the warning
light comes on with the engine running. The battery is not charged any more (
➠
page
5-15.
Important! Important!
The coolant pump no longer runs if the V-belt is faulty.
Possibility of engine overheating or breakdown!
If warning light 1935 comes on with the engine running:
☞
Switch off the engine immediately and repair or have the cause repaired
36 Warning Light (red) – coolant temperature
Comes on if coolant temperature is too high. A buzzer sounds at the same time. The warn-
ing light and the buzzer go out as soon as the coolant temperature is back in the accept-
able range.
WARNING!
Never open the coolant tank and never drain coolant if the engine is warm,
because the cooling system is under high pressure –
Danger of burns!
☞
Wait at least 10 minutes after turning off the engine!
☞
Wear protective gloves and clothing
☞
Always start by actuating the safety valve in the cap of the expansion tank.
To do this: Turn the cap to the first notch and allow the pressure to escape
Important! Important!
Possibility of engine breakdown if warning light 19/36 comes on with the
engine running!
☞
After extreme work load:
Let the engine run at idle until the warning light goes out
☞
After normal workload or if the warning light does not go out as described
above:
Turn off the engine immediately
☞
Check and correct the coolant level (
➠
page 5-10)