![background image](http://html1.mh-extra.com/html/gehl/418t-wheel/418t-wheel_operators-manual_2205856144.webp)
AP0902
5–31
Maintenance
5.11.2
Wheel change
WARNING!
Use of wrong tires or wheels can be hazardous.
☞
Use only the wheels and tires released for your machine – see section 7
“Tires” on page 7-7
☞
Check the wheel nuts for tightness after every wheel or tire change
Important!
The wheels are heavy and can damage the threads on the wheel studs if they
are handled incorrectly!
☞
Use suitable assembly tools, such as covering sleeves for the studs, a jack,
etc.
Removing the wheels
☞
Proceed as follows:
• Park the machine on level and firm ground and prevent it from rolling away.
• Slightly loosen the wheel nuts of the tire you want to remove.
• Place a jack under the axle beam, making sure it is well supported.
• Raise the side of the axle from which you want to remove the tire.
• Check that the machine is well supported.
• Completely remove the wheel nuts
• Remove the wheel
Installing the wheels
☞
Proceed as follows:
• Place the wheel onto the wheel studs
• Tighten all the wheel nuts part-way
• Lower the raised axle
• Tighten the wheel nuts to the prescribed tightening torque– see section 7.16.2 Spe-
cific tightening torques on page 7-9
Summary of Contents for 418T Wheel
