5–8
AP0902
Maintenance
5.3.3
Changing the engine oil
WARNING!
Use extra caution when draining hot engine oil, because of the risk of burns.
☞
Wear protective gloves
☞
Use suitable tools
Environment!
Collect the drained engine oil in a suitable container and dispose of it by an ecologically
safe method!
☞
Change the engine oil as follows:
•
Park the machine on level ground
•
Let the engine run until reaching operating temperature [oil temperature about 180 °F
(80 °C)]
•
Switch off the engine
•
Remove maintenance panel A under the machine rear end. To do this:
Release screws B
•
Place an oil drip tray [with a capacity of about 8 quarts (8 liters)] under the opening
•
Unscrew filler cap C of oil drain valve E
•
Unscrew oil drain coupling D with a sufficiently long hose, making sure the end of the
hose is in the oil drip tray
➥
Oil drain valve E opens and the engine oil drains
•
Completely drain the oil
•
Unscrew oil drain coupling D
•
Screw on filler cap C of the oil drain valve
•
Fit maintenance panel A
•
Fill with engine oil – see section 5.3.2 Topping up the engine oil on page 5-7
•
Start the engine and run it at low speed for a short time
•
Switch off the engine
•
Wait a moment until all the oil has run into the oil sump
•
Check the oil level again
•
Top up if necessary and check again
•
Completely remove all oil spills from the engine
Fig. 138: Maintenance panel
A
B
Fig. 139: Engine oil drain plug
C
C
D
E
Summary of Contents for 418T Wheel
