Gehl 418T Wheel, Operator'S Manual

Page: 53 / 192

3–16
AP0902
Operation
3 3.4.3 Before starting the engine
1
☞
Run through the “Start-up” checklist on page 3-6
☞
Adjust seat position and rearview mirror
CAUTION!
All controls must be within easy reach. You must be able to move the brake and
accelerator pedals to their limit positions!
☞
Fastening the seat belt
☞
Be sure that:
– Parking brake 16/25 is applied; and
– Control lever 16/21 and 16/22 are in neutral
3.4.4 Starting the engine
General
•
The engine will start only if parking brake 16/25 is applied
•
The starter cannot be operated if the engine is already running (start repeat interlock)
•
Do not run the starter for more than 10 seconds
•
Wait for about 1 minute to let the battery recover before trying again
•
The engine cannot be started by towing the machine, because there is no driving
connection between the engine and gearbox when the engine is off
Procedure
☞
After you have completed the starting preparations in accordance with 3.4.3 Before
starting the engine
• Insert the ignition key into the preheating start switch 33/52
• Turn the ignition key to position “1”
• Check whether the following warning lights come on:
• Warning Light 40 for engine oil pressure
• Warning Light 35 for alternator charge function
• Warning Light 41 if the parking brake is applied
• During the warning light check, warning lights
36, 37, 38 and 39 must come on as well, and the warning buzzer must sound
• Replace defective warning lights immediately
• Press the accelerator pedal 16/6 through about a quarter of its travel
• Turn the ignition key to position “3” and hold it in this position until the engine starts
• Release the ignition key
When the engine has started ...
☞
Check that the following warning lights have gone out:
• Warning Light 34/35
• Warning Light 34/40
• Warning Lights 34/36, 37, 38 and 39
☞
Run the engine warm
1
0
2
3
Fig. 33: Preheating start switch
52
35
40
41
Fig. 34: Warning Lights
36
37
38
39
44
Operation