3–58
AP0902
Operation
3.5.11
Working with standard bucket and pallet forks
Standard bucket
The following section describes work operations with the machine equipped with the stan-
dard bucket.
The standard bucket is mainly used for digging earth, and for loosening, lifting, transport-
ing and loading loose or solid materials.
Checking the tilt position of the bucket
NOTE:
Angle of red marking A on top of the bucket is the same as the angle of the cutting
blade B.
Checking the transport position of the bucket
NOTE:
The bucket is in transport position when the
• Telescopic unit is fully retracted and
• Bucket is rolled back in completely (A) and
• Marks C on the lift frame and the machine frame are lined up (figure 106)
With both marks C aligned, transport ground clearance will be at least 10 in
(230 mm). (105/B), with standard bucket (810136) and standard tires (12.5-20).
Fig. 104: Tilt position of the bucket
A
B
B
A
Fig. 105: Transport position of the bucket
Fig. 106: Marks for transport position
C
Summary of Contents for 418T Wheel
