AP0902
5–25
Maintenance
5.8.3
Front and rear axle planetary drives
NOTE:
Fit new sealing rings! Drain oil only after running the machine for a longer period of
time!
Checking the oil level
☞
Proceed as follows:
• Park the machine on level ground
• Turn plug A and oil level mark B to a horizontal position
• Clean and unscrew plug A
If the oil level is below opening C or if the oil level cannot be seen at all:
• Top up with oil – see section 5.15 Engine fluids and lubricants on page 5-39
• Tighten plug A with a new sealing ring A to ensure an oil-tight seal
Top up the oil level
☞
Proceed as follows:
• Park the machine on level ground
• Turn plug 159/A and oil level mark 159/B to a horizontal position
• Clean and unscrew plug 159/A
• Fill with fresh oil up to the oil level mark 159/2 (overflow) – see section 5.15 Engine
fluids and lubricants on page 5-39
• Tighten plug 159/A with a new sealing ring 159/D to ensure an oil-tight seal
Changing the oil
☞
Proceed as follows:
• Park the machine on level ground when it is at operating temperature
• Place a suitable container under plug A
• Turn plug A to the topmost position
• Clean and unscrew plug A
Never raise the machine on one side only for the following work!
• Turn plug A to the lowest position
• Completely drain the old oil
• Turn plug A and oil level mark B to a horizontal position
• Fill with fresh oil up to oil level mark B (overflow) – see section 5.15 Engine fluids and
lubricants on page 5-39
• Tighten plug A with a new sealing ring A to ensure an oil-tight seal
2
A
Fig. 159: Checking the oil level in the planetary gear
B
C
D
2
A
Fig. 160: Checking the oil level in the planetary gear
B
C
D
Summary of Contents for 418T Wheel
