![background image](http://html1.mh-extra.com/html/gehl/418t-wheel/418t-wheel_operators-manual_2205856033.webp)
2–10
AP0902
Safety instructions
•
The fastening of loads and the instructing of lift operators must be done by experienced
persons only!
The person giving the instructions to the operator must be within sight or sound of him.
•
For overhead assembly work, always use specially designed or otherwise safety-
oriented ladders and work platforms.
Never use machine parts or attachments/superstructures as a climbing aid!
Wear a safety harness when carrying out maintenance work at greater heights!
Keep all handles, steps, handrails, platforms, landings and ladders free from dirt, snow
and ice!
•
Clean the machine, especially connections and threaded unions, of any traces of oil,
fuel or preservatives before carrying out maintenance/repair work!
Do not use aggressive detergents!
Use lint-free cleaning rags!
•
Before cleaning the machine with water, steam cleaning (high-pressure cleaning) or
using detergents, cover or tape up all openings that– for safety and functional reasons
– must be protected against water, steam or detergents. Special care must be taken
with the electrical system.
•
After cleaning, remove all covers and tapes applied for that purpose!
•
After cleaning, examine all fuel, lubricant and hydraulic oil lines for leaks, chafe marks
and damage!
Any defects found must be corrected without delay!
•
Tighten any screw connections that have been loosened during maintenance and
repair!
•
Any safety devices removed for set-up, maintenance or repair purposes must be
refitted and checked upon completion of the maintenance and repair work.
•
Ensure that all fluids and replaced parts are disposed of safely and with minimum
environmental impact!
•
Do not use the work tools as lifting platforms for persons!
•
Before working on a machine parts/attachments move and cause injury (bruising,
cutting), always ensure safe blocking/support of these components.
•
Perform maintenance and repair work beneath a raised machine, work tool/attach-
ments or additional equipment only if a safe and secure support has been provided
(The use of hydraulic cylinders, jacks, etc. does not sufficiently secure raised machines
or equipment/attachments).
•
Avoid contact with hot parts, such as the engine block or the exhaust system during the
operation of the machine and for some time afterwards – danger of burns!
•
Retainer pins can fly out or splinter when struck with force – be careful to avoid
personal injury!
•
Do not use starting fluid (ether)! This especially applies to those cases in which a
heater plug (intake-air preheating) is used at the same time – because of the danger of
explosions!
•
Use special care when working on the fuel system – because of the increased danger
of fire!
Summary of Contents for 418T Wheel
