3–68
AP0902
Operation
Setting down the material
☞
Proceed as follows:
•
Move straight ahead to the stack with the telescopic unit retracted and lowered to
transport position, and the fork frame slightly tilted back
•
Apply parking brake 16/25
•
Set drive switch to neutral – see Driving direction selector switch on page 3-8
•
Raise the telescopic unit (1)
•
Carefully extend the telescopic unit (2) until the load is positioned precisely above the
stack
•
Put the fork arms level again (3)
•
Lower the telescopic unit slowly (4), making sure that the preset limits of load
diagram and safe load indicator are not exceeded! In case of doubt or danger, stop
stacking immediately! To do this:
• First retract the telescopic unit and then
• Lower the telescopic unit
•
To align the load with the stack, carefully retract/extend the telescopic unit
•
Lower the load
•
Make sure that the fork arms are free from load and that nothing/nobody is in your
way, before reversing from the stack
•
Retract the telescopic unit
•
Lower the telescopic unit to transport position
•
Tilt the fork frame to the back
Fig. 128: Lift the telescopic unit
4
3
2
1
Summary of Contents for 418T Wheel
