![background image](http://html1.mh-extra.com/html/gehl/418t-wheel/418t-wheel_operators-manual_2205856042.webp)
AP0902
3–5
Operation
3
3.3
Placing into service
3.3.1
Safety instructions
•
Only use the steps and handles provided when entering and leaving the cab
•
Never use the controls or movable lines and cables as handles
•
Never jump on or off a moving machine
•
Refer to the corresponding load diagrams for the loader unit pallet forks
3.3.2
Placing the machine into service for the first time
Important information
•
The machine may be placed into service by authorized personnel only
•
The operating personnel must have read and understood this operator’s manual before
placing the machine into service
•
The machine may only be used in good condition in accordance with its designated use
and the instructions set out in the operator’s manual, and only by persons who are fully
aware of the risks involved in operating the machine
•
Go through the “Start-up” checklist in the following section
Running-in period
Operate the machine carefully during its first 100 operating hours.
The future performance and service life of the machine are heavily dependent on the
observance of the following recommendations during the running-in period.
•
Do not overload the machine, but at the same time do not drive too cautiously either, as
the machine will never reach the proper operating temperature
•
Do not run the engine at high speeds for extended periods
•
Increase the load gradually while varying the engine speed
•
Strictly observe the maintenance schedules in the Annex
Operation
Summary of Contents for 418T Wheel
