![background image](http://html1.mh-extra.com/html/gehl/418t-wheel/418t-wheel_operators-manual_2205856145.webp)
5–32
AP0902
Maintenance
5.12 Heating
The heating system of the machine is equipped with a dust filter, which should be cleaned
at regular intervals and replaced once a year, as appropriate.
The heating system is located on the right front of the cab.
5.12.1
Cleaning the dust filter of the heating system
A dust filter cleans the air taken in by the heater. Blow compressed air through the filter as
often as necessary, but at least once a year. The volume of warm air flowing out of the air
vents decreases as filter contamination increases.
☞
Clean the filter as follows:
•
Remove cover A at the front right of the cab as follows:
☞
Remove screws B
•
Remove dust filter C
•
Clean or replace dust filter C
•
Re-insert the cleaned dust filter and install cover C
Fig. 165: Replacing the cover of the heating system
B
A
Fig. 166: Replacing the dust filter of the heating system
C
Summary of Contents for 418T Wheel
