3–44
AP0902
Operation
What to do if...
•
Green LED d comes on?
➥
OK; load indicator is ready
•
Green LEDs a (1-6) come on?
➥
OK; the load is between 45% and 90% of the safe work load
•
Yellow LEDs b (7-8) come on in addition?
➥
Work with caution; the load is between 85% and 100% of the safe work load
•
Green a and yellow LEDs b are flashing, the acoustic signal is given?
➥
Work with extreme caution! 100% of the safe work load is reached corre-
sponding to the load diagram
•
Red LEDs c come on?
➥
OVERTURNING HAZARD! Reduce the load immediately by retracting the
telescopic unit! The load is between 100% and 110% of the safe work load!
•
The complete indicator is flashing, the acoustic signal is given, although the TEST tip
switch has not been activated?
➥
The load indicator is defective. Have it immediately checked and repaired by an
expert!
Functional check
NOTE:
The check may be performed at any time, even during operation.
☞
Proceed as follows:
•
Press TEST tip switch e
All LEDs are flashing and the acoustic signal is given:
➥
In working order
Acoustic signal sounds uninterruptedly for 10 seconds, then 2 red and 1, 2 or 3 green
LEDs come on in addition:
➥
System error; have the safe load indicator immediately be checked and repaired by
an expert!
Adjusting signal volume
☞
Proceed as follows:
•
Press TEST tip switch e
While the acoustic signal is given:
•
Press the MUTE tip switch f until the desired volume is set
Summary of Contents for 418T Wheel
