background image

Form No. 3441-531 Rev A

TX 525 Compact Tool Carrier

Model No. 22323—Serial No. 407600000 and Up

Operation and Safety Guide

In addition to this guide, please read the full

Operator’s Manual

, which you can obtain from the rental center

or from www.Toro.com. To download the manual from www.Toro.com, you will need the product model and
serial number, listed above.

WARNING

CALIFORNIA

Proposition 65 Warning

Diesel engine exhaust and some of its constituents are known to the State of California

to cause cancer, birth defects, and other reproductive harm.

Battery posts, terminals, and related accessories contain lead and lead

compounds, chemicals known to the State of California to cause cancer and

reproductive harm. Wash hands after handling.

Use of this product may cause exposure to chemicals known to the State of California

to cause cancer, birth defects, or other reproductive harm.

Safety

This machine is a compact tool carrier intended for
use in various earth and materials moving activities for
landscaping and construction work. It is designed to
operate a wide variety of attachments each of which
perform a specialized function. Using this product
for purposes other than its intended use could prove
dangerous to you and bystanders.

General Safety

DANGER

There may be buried utility lines in the work
area. Digging into them may cause a shock
or an explosion.

Have the property or work area marked for
buried lines and do not dig in marked areas.
Contact your local marking service or utility
company to have the property marked (for
example, in the US, call 811 or in Australia,
call 1100 for the nationwide marking service).

Always follow all safety instructions to avoid serious
injury or death.

Do not carry a load with the arms raised; always
carry loads close to the ground.

Slopes are a major factor related to loss-of-control
and tip-over accidents, which can result in severe
injury or death. Operating the machine on any
slope or uneven terrain requires extra caution.

Operate the machine up and down slopes with
the heavy end of the machine uphill and the load
close to the ground. Weight distribution changes
with attachments. An empty bucket makes the
rear of the machine the heavy end, and a full
bucket makes the front of the machine the heavy
end. Most other attachments make the front of the
machine the heavy end.

Have the property or work area marked for buried
lines and other objects, and do not dig in marked
areas.

Read and understand the content of this

Operation

and Safety Guide

before starting the engine.

Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.

Never allow children or untrained people to
operate the machine.

Keep your hands and feet away from the moving
components and attachments.

Do not operate the machine without the guards
and other safety protective devices in place and
working on the machine.

© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420

Register at www.Toro.com.

Original Instructions (EN)

Printed in the USA

All Rights Reserved

*3441-531*

 

Summary of Contents for 22323














Reviews: