GCC Technologies Elite 21 Series, User Manual

Page: 95 / 311

4-2
Software Installation
The software required to set up your Windows 95/98 or Windows ME computer is
located on the Elite 21 Series CD-ROM.
You can install the Elite 21 software on your computer using Plug and Play. This will
work if you are installing the software on a computer which is connected to the
printer through the parallel or USB (Win98/ME only) port.
If the printer is not connected to the computer through the parallel or USB port, go to
the “Using Add Printer” section immediately following Plug and Play instructions.
USB connection of the printer is not supported under Windows 95. If installing the
printer over USB using Windows 98 or Windows ME, follow the USB Plug and Play
installation instructions on
Page 4-3 (Win98) or Page 4-7 (WinME).
Windows 95/98/ME uses a Wizard to help you install printer software. A Wizard is a
series of dialog boxes. In each dialog box you make configuration choices then click
the Next button to move to the next dialog box.
Windows 95/98 Only: Part of the software you will need is contained on the Windows
95/98 CD-ROM or floppy disks. Please have this software available when doing the
installation.
Note: These instructions cover installing the Elite 21 as a local printer (connected via
a USB or parallel) on a Windows 95/98/ME PC.
If installing the printer as a stand-alone Ethernet device on a Windows network, we
recommend following the “Using Add Printer” instructions as if the printer were being
installed as a local device on port LPT1:. Once the installation is complete, proceed to
the
Windows 95/98/ME section of Chapter 8 of this Manual (Networking the Elite 21
Printer) for instructions for setting up the printer as an Ethernet network device.
Installing the Elite 21 with Windows 95/98/ME