11-10
1.
Check the printer’s display to make sure
the unit is in the Ready mode.
Switch off the printer’s power switch at
the front of the unit and unplug the
printer’s AC power supply from its outlet.
Caution:
The fusing unit of the printer
will be very hot directly after printing.
Wait at least 30 minutes to let the fuser
cool down before servicing the fuser.
2.
Squeeze the latch at the upper left of the
rear panel and pull towards you to open
the rear cover of the printer.
If you are using a paper cassette extended
past the Letter/A4 setting, remove the
cassette before opening the rear cover.
Replacing the Fuser
The Fuser is used for fixing toner onto the paper. It should be replaced after approximately 200,000 sheets
have been printed. Depending on operating conditions, however, the fuser may need to be replaced before
or after that interval is reached. Instructions for replacement of the fuser are as follows:
Summary of Contents for Elite 21 Series
