GCC Technologies Elite 21 Series, User Manual

Page: 45 / 311

Remove DRAM DIMM:
Install DRAM DIMM:
1-37
4. This will expose the main controller
board of the printer. The DIMM slot is
mounted vertically near the right of the
board.
5. If replacing existing memory with a larger
capacity DIMM, remove the existing
DIMM as shown. Open the clips at the
ends of the slot (1) and gently pull the
DIMM straight out of the slot (2).
Install the new DIMM by opening the two
white clips at the ends of the slot,
positioning the DIMM above the slot, and
gently pressing it down into the slot (1).
Lift up the two clips to lock the DIMM in
place (2). The clips should lift and lock
easily, if not the DIMM may not be
properly seated. In this case, gently pull
the DIMM straight out of the slot and try
installation again.
DMM Slot