Fuji Xerox DocuCentre S2110, User Manual

Page: 23 / 229

Setting the Network Environment
23
Environme
n
t Se
ttings
2
Setting the Network Environment
This section describes how to make the settings needed to use the TCP/IP protocol.
Note
z The machine supports IPv6 addresses in an IPv6 network environment. For more information, refer to
"Setting the Machine's IP Address (IPv6)" (P.23).
Setting the Machine's IP Address (IPv4)
To use the TCP/IP protocol, you must set the machine's IP address.
By default, the machine is set to obtain its IP address automatically.
This setting automatically sets the machine's IP address when the machine is connected to
a network containing a DHCP server.
Print the System Settings Report to check whether the machine's IP address has already
been set.
If the machine's IP address has not been set, you will need to set the IP address on the
control panel.
Note
z If the network has a DHCP server, the machine's IP address may be changed, so check the address
periodically.
z
The machine can acquire address information automatically by using a BOOTP or RARP server.
Reference
z
For information on how to print the System Settings Report, refer to "Printing Reports" (P.142).
z For information on how to set the IP address from the control panel, refer to "Network Settings" (P.132).
After setting the program numbers from 1008 to 1020, print out the System Settings Report, and check the
applied settings.
Setting the Machine's IP Address (IPv6)
The machine supports IPv6 addresses in an IPv6 network environment.
The machine's IP address type is set to IPv4 by factory default. To use the machine in an
IPv6 network environment, set the IP address type to IPv6 or both types. The IPv6 address
is set automatically when the machine is restarted.
Print the System Settings Report to check the IPv6 address.
You can set a fixed IPv6 address for the machine using either of the following methods:
z
Use the control panel to make the setting manually.
z
Use CentreWare Internet Services to make the setting manually. Print the System
Settings Report to check the address set automatically, then use that address to access
CentreWare Internet Services.
From the [Properties] tab, select [Connectivity] > [Protocols] > [TCP/IP] > [IP Mode]. Set
the [IP Mode] to [IPv6] or [Dual Stack]. The IPv6 address can be entered manually if the
[Enable Manual Address] checkbox is checked under [IPv6].
Reference
z
For information on how to print the System Settings Report, refer to "Printing Reports" (P.142).
z
For information on how to make settings from CentreWare Internet Services, refer to "Setting Items on
CentreWare Internet Services" (P.29).