Foerster TAK5-CH1-25, Instruction Manual

Page: 58 / 226

58 Setup
Address
Each node of the CAN-bus system requires an address for clear
identification purposes.
Operating mode
Do not change the preset value SA (= Stand Alone).
Here you select whether the automatic feeder is equipped with a
heating and if so, the heating relay type. With here you must
select electronic , with mechanical .
HE-capacity
With 250 ml, with 500 ml must be set. The set value
determines:
•
The target quantity for the calibration of water HE and milk
machine
type: Combi
number: 1
address: [10]
...
Note: Make sure that a number is assigned only once.
address
already allocated!
Note: If you select an address that has already been as-
signed, the message on the right will be displayed.
Address ranges for CAN-nodes
1-10 => Hand-held terminal
11-20 => Automatic feeder
41-50 => IFS-feed control single
51-60 => IFS-concentrate feeder
61-70 => IFS-feed control quadruple
machine
...
operating mode: [SA]
...
machine
...
heating: [electronic]
...
machine
...
HE-cap.:[500] ml
...