Foerster TAK5-CH1-25, Instruction Manual

Page: 48 / 226

48 Start-up
2. The fault message on the right is displayed. Press .
3. Confirm HE fill? with . The boiler of the heat exchanger is
automatically filled with water.
3.9 Portion
In this menu you can carry out the settings for the feed portion:
•
The target temperature of the feed in the mixer jar,
•
The minimum temperature of the water in the boiler,
•
The distribution pause,
•
The portion dispense when entitlement less than 250 ml,
•
The tolerance values for the concentration and the milk ra-
tio.
3.9.1 Adjusting the target (set) and the minimum temperature
1. > device data > portion > set temp. resp. min. temp.
2. In set temp. enter the desired target temperature of the feed
in the mixer jar (= mixing temperature).
3. In min. temp. enter the desired minimum temperature of the
water in the boiler.
Note: After you have switched the automatic feeder on,
the program version of the hand-held terminal is briefly
displayed before the automatic feeder starts carrying out
a check routine. Do not press any key during these start
routines.
failure
HE not filled
HE not filled
HE: fill?
mixer: empty?
water bo.: start?
portion
set temp.: [41.0]ºC
min. temp.: 38.0 ºC
qty <250 ml: no
tol. conc.: 20 g/L
tol. milk: 0 %
portion
set temp.: [41.0]ºC
min. temp.: 38.0 ºC
...