9 Measurement
9.2 Measurement settings
FLUXUS G831ST-HT
2021-06-01, UMFLUXUS_G831ST-HTV1-0EN
82
Assignment of a source item
A source item has to be assigned to each selected output.
• Select a source item whose measured value, status value or event value is to be transmitted to the output.
• Press ENTER.
Options\Outputs\...\Source item
Tab. 9.1:
Configuration of the outputs
source item
list item
output
Flow quantities
Flow velocity
flow velocity
Operation vol. flow
operating volumetric flow rate
Mass flow rate
mass flow rate
Totalizers
Volume (+)
totalizer for the volumetric flow rate in positive flow direction
Volume (-)
totalizer for the volumetric flow rate in negative flow direction
Volume (Δ)
difference of the totalizers for the positive and negative flow direction
Mass (+)
totalizer for the mass flow rate in positive flow direction
Mass (-)
totalizer for the mass flow rate in negative flow direction
Mass (Δ)
difference of the totalizers for the positive and negative flow direction
Fluid properties
Fluid temp.
fluid temperature
Fluid pressure
fluid pressure
Fluid density
fluid density
Kin. viscosity
kinematic viscosity
Dyn. viscosity
dynamic viscosity
Compress. coeff.
gas compressibility coefficient
Event trigger
R1
limit message (
Event trigger R1
)
R2
limit message (
Event trigger R2
)
R3
limit message (
Event trigger R3
)
R4
limit message (
Event trigger R4
)
Diagnostic values
Crest factor
signal-to-noise ratio for the cross correlation function
Transducer temp.
transducer temperature
Miscellaneous
Custom. Input 1
measured values of input quantities (e.g., temperature, density) which are
not used for calculation
In the menu item
Options\Assign inputs
it is possible to assign
configured inputs to customized inputs.
Custom. Input 2
Custom. Input 3
Custom. Input 4
