6 Mounting
FLUXUS G831ST-HT
6.2 Transducers
33
UMFLUXUS_G831ST-HTV1-0EN, 2021-06-01
• Place the tension strap around the pipe and insert it into the clasp, see Fig. 6.13.
• Tighten the tension strap.
• Tighten the clasp screw.
Ratchet clasp
• Insert the tension strap into its clamps and the metal spring (see Fig. 6.15).
• Position the ratchet clasp, the tension strap clamps and the metal spring on the pipe (see Fig. 6.11):
– On a horizontal pipe, mount the tension strap clamps laterally to the pipe, if possible.
– Mount the metal spring opposite the ratchet clasp.
• Make sure that both tension strap clamps are as exactly as possible opposite each other. To do this, check whether the
distance between the tension strap clamps is half the pipe circumference.
• Place the tension strap around the pipe and pass it through the slot of the clasp screw, see Fig. 6.16.
• Tighten the tension strap.
• Cut off the protruding tension strap, see Fig. 6.16.
• Tighten the clasp screw.
Fig. 6.14: Tension strap with band clamp
clasp
1 – clasp screw
Caution!
The edge of the tension strap is very sharp.
Risk of injury!
→ Debur sharp edges.
→ Wear the required personal protective equipment.
→ Observe the applicable rules.
Notice!
In order to release the screw and the tension strap, press the lever down, see Fig. 6.16.
Fig. 6.15: Tension strap with metal spring and clamp
1 – metal spring
2 – tension strap clamp
1
1
2
