Extreme Networks BlackDiamond 8810, Hardware Installation Manual

Page: 95 / 162

Installing I/O Modules
Extreme Networks Consolidated XOS Hardware Installation Guide
95
8 Ensure that the module is vertical with the module name at the top, the PCB to the right, and that
the ejector/injector levers are extended, as shown in
Figure 45 .
Figure 45: Module injector/ejector levers and captive screws
a Slide the module into the appropriate slot of the chassis until it makes contact with the
backplane.
NOTE
Use the metal panel, not the PCB, to guide the I/O module
As the module begins to seat in the chassis, the ejector/injector levers begin to close.
b To close the ejector/injector levers, use both hands simultaneously to push the levers toward the
center of the module, as shown in
Figure 45 .
c To secure the module, tighten the two captive screws using a #1 Phillips screwdriver.
NOTE
Tighten the screws of this module before inserting additional modules. Otherwise, you might unseat modules that
you have not secured.
9 Store the module packaging for future use.
To install additional I/O modules, repeat steps 3 through 9.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available when you
need to handle ESD-sensitive components.
EX_017
Captive
screws
Open
Open
Open
Injector/
ejector lever
Injector/
ejector lever Open
Lock
Lock
Lock
Lock