Extreme Networks BlackDiamond 8810, Hardware Installation Manual

Page: 44 / 162

Overview
Extreme Networks Consolidated XOS Hardware Installation Guide
44
To insert a mini-GBIC connector:
NOTE
Mini-GBICs can be installed in the SFP mini-GBIC receptacles only.
1 Holding the mini-GBIC by its sides, insert the mini-GBIC into the SFP receptacle on the switch or
module.
2 Slide the mini-GBIC into the SFP receptacle until you hear an audible click, indicating the mini-GBIC
is securely seated into the SFP receptacle. If the mini-GBIC has a handle, push up on the handle to
secure the mini-GBIC.
Installing and Removing a XENPAK Module
This section describes installing and removing the XENPAK module, a 10 Gbps optical transceiver. You
can install or remove the XENPAK module from your Extreme Networks switch without powering off
the system. The module is shown in
Figure 11 .
Figure 11: XENPAK module
The XENPAK module is a Class 1 laser device. Use only Extreme-approved devices on all Extreme
Networks switches.
CAUTION
The XENPAK module can emit invisible laser radiation. Avoid direct eye exposure to beam.
WARNING!
To prevent ESD damage to the XENPAK module, always use an appropriately grounded ESD-preventive wrist strap
when installing or removing the module. Handle the module by its sides only. Never touch the card-edge connectors
at the insertion end of the module.
EWUG003B
Card edge
connector