Extreme Networks BlackDiamond 8810, Hardware Installation Manual

Page: 103 / 162

Installing the BlackDiamond 10K Series Fan Tray
Extreme Networks Consolidated XOS Hardware Installation Guide
103
4 Allow the fan blades to stop spinning completely and remove the fan tray from its slot.
WARNING!
Keep your hands away from rotating fan blades.
5 To support the fan tray, place one hand under the fan tray; use the other hand to pull the fan tray
from its slot.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available when you
need to touch ESD-sensitive components.
Installing the BlackDiamond 10K Series Fan Tray
The BlackDiamond 10K series fan trays are hot-swappable. You do not need to turn off power to a
BlackDiamond 10K series switch to install the fan tray.
You need the following tools and equipment to install a fan tray:
●
ESD-preventive wrist strap
●
# 1 Phillips screwdriver
●
Replacement fan tray
WARNING!
Service to all equipment should be performed by
trained and qualified service personnel only!
Before installing or
removing any components of the system, or before carrying out any maintenance procedures, you must read the
safety information provided in
Appendix A of this guide.
To install the fan tray in the BlackDiamond 10K series switch:
1 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
switch front panel, as shown in Figure 9.
2 Check the connectors on the switch fan tray for dust and packing materials.
3 To support the fan tray, place one hand under the fan tray; use the other hand to guide the fan tray
into the slot.
Gently begin to insert the new fan tray into the slot.
NOTE
If the chassis is powered on, the fan blades will begin turning as soon as the tray makes contact with the
backplane.
4 To secure the fan tray, turn the screws clockwise using the screwdriver until they become tight.