Extreme Networks BlackDiamond 8810, Hardware Installation Manual

Page: 127 / 162

Installing Aspen 8810 MSM and I/O Modules
Extreme Networks Consolidated XOS Hardware Installation Guide
127
G48P Port LEDs
In addition, the port LEDs on the PoE blades (G48P) have indications about the inline power delivered
through the ports.
Table 22 describes the LED activity on the G48P module for each port
Installing Aspen 8810 MSM and I/O Modules
This section describes important safety information and correct procedures for installing an Aspen 8810
MSM or I/O module. All Aspen modules are hot-swappable. You do not need to power the system off
to install an Aspen module. This chapter covers the following topics:
●
Pre-Installation Requirements on page 127
●
Distinguishing an Aspen 8810 MSM from an I/O Module on page 128
●
Installing an Aspen 8810 MSM or I/O Module on page 129
●
Removing an Aspen 8810 MSM or I/O Module on page 131
Pre-Installation Requirements
You will need the following tools and equipment to install an Aspen 8810 MSM or I/O module:
●
ESD-preventive wrist strap
●
#2 Phillips screwdriver
●
Aspen 8810 chassis
●
Aspen 8810 MSM or I/O module
Table 22: Port LEDs for the G48P module
LED Color Indicates
Port with power enabled Solid amber
Slow amber blinking
Amber blinking
Slow amber blinking
Blinking amber/green
Link up
Port disabled
Activity
Link down
Power fault or insufficient power
Port with power disabled Solid green
Slow green blinking
Green blinking
Off
Blinking amber/green
Link up
Port disabled
Activity
Link down
Power fault or insufficient power