Extreme Networks BlackDiamond 8810, Hardware Installation Manual

Page: 101 / 162

Extreme Networks Consolidated XOS Hardware Installation Guide
101
8 BlackDiamond 10K Series Fan Tray and Filter
This chapter describes:
●
BlackDiamond 10K Series Fan Tray on page 101
●
Removing the BlackDiamond 10K Series Fan Tray on page 102
●
Installing the BlackDiamond 10K Series Fan Tray on page 103
●
Replacing the BlackDiamond 10K Series Filter on page 104
NOTE
Read the information in this chapter thoroughly before you attempt to install or remove any BlackDiamond 10K
series fan tray.
BlackDiamond 10K Series Fan Tray
The BlackDiamond 10K series fan tray, which is pre-installed at the factory:
●
Contains two individual fans
●
Is hot-swappable, which means you can remove and replace the fan tray without powering down
the switch
●
Can be removed and installed by customers
CAUTION
Do not cover or obstruct the fan ventilation holes at the rear of the unit. Doing so can result in overheating and
possible damage to the BlackDiamond 10K series switch. Thermal sensors will shut down the BlackDiamond 10K
series switch if the internal temperature exceeds 60 degrees Celsius.
The software monitors the fan trays in the BlackDiamond 10K series switch for overheat conditions. All
over-temperature events cause the switch to send alerts to the network management station or to the
switch log. See the ExtremeWare XOS Concepts Guide for more information about switch monitoring.