Extreme Networks BlackDiamond 8810, Hardware Installation Manual

Page: 25 / 162

Evaluating and Meeting Cable Requirements
Extreme Networks Consolidated XOS Hardware Installation Guide
25
Installing Cable
Consider the following recommendations when you connect cable to your network equipment:
●
Examine cable for cuts, bends, and nicks.
●
Support cable using a cable manager that is mounted above connectors to avoid unnecessary weight
on the cable bundles.
●
Use cable managers to route cable bundles to the left and right of the network equipment to
maximize accessibility to the connectors.
●
Provide enough slack, approximately 2 to 3 inches (5.08 to 7.62 cm), to provide proper strain relief as
shown in
Figure 5 .
●
Bundle cable using velcro straps to avoid injuring cables.
●
If you build your own cable, ensure that cable is properly crimped.
●
When installing a patch panel using twisted pair wiring, untwist no more than 1 inch (2.54 cm) of
the cable to avoid radio frequency (RF) interference.
●
Discharge the RJ45 Ethernet cable before plugging it into a port on the switch.
●
When required for safety and fire rating requirements, use plenum-rated cable. See your local
building codes for determining when it is appropriate to use plenum-rated cable, or refer to IEC
standard 850.
●
Keep all ports and connectors free of dust.
WARNING!
Unshielded twisted pair (UTP) cable can build up ESD charges when being pulled into a new installation. Before
connecting any category 5 UTP cable to the switch, discharge ESD from the cable by plugging the RJ45 into a LAN
Static Discharge device or use an equivalent method.