Epson EB-L1050U, User Manual

Page: 77 / 291

Each time you press the [Color Mode] button, the Color Mode name is
displayed on the screen and the Color Mode changes.
Remote control
a
You can set Color Mode from the Configuration menu.
s
Image - Color Mode p.140
Setting the Brightness
Set the brightness for the light source.
a
Press the [Menu] button while projecting.
b
Select Brightness Settings from Settings .
c
Select Light Source Mode , and then press the [ ] button.
d
Select the item you want to set, and then press the [ ] button.
Normal : Select this if you do not want to decrease the brightness.
This makes the light source operation time approximately 20,000
hours.
Medium : Noise from the fan is louder than when Quiet is selected,
but it does not decrease the brightness as much. This sets the
brightness at 85%. This makes the light source operation time
approximately 20,000 hours.
Quiet : Select this if you are concerned about the noise made by the
fan. This sets the brightness at 70%. This makes the light source
operation time approximately 20,000 hours.
Extended : Select this to extend the life expectancy of the light
source. This sets the brightness at 70%. This makes the light source
operation time approximately 30,000 hours.
Custom : Select this to set the Brightness Level manually. When
Custom is selected, Constant Brightness is available.
e
When Light Source Mode is set to Custom , select Brightness
Level , and then use the [ ][ ] buttons to set the brightness.
f
To maintain a fixed brightness, select Constant Brightness , and
set it to On .
a
•
When Constant Brightness is set to On , you cannot change
the settings for Light Source Mode and Brightness Level .
When you want to change these settings, set Constant
Brightness to Off .
•
When Constant Brightness is set to Off , the value for
Brightness Level changes depending on the current status of
the light source.
•
There may be a margin of error in the Brightness Level .
•
When the projector is used continuously for more than 24
hours, or when direct shutdown is used regularly, set
Light
Source Calibration using the scheduling function. If this is
not set, the Constant Brightness function does not work. You
can also make settings from the Configuration menu.
s
"Scheduling Function" p.112
s
Reset - Light Source Calibration p.162
Adjusting the Projected Images
77